ΚΑΜΕΡΑ CONNECTS2 VISION CAM-17

Description

Universal reverse camera CAM-17 - Features

• Universal reverse parking camera.
• Drill to Fit Reverse Camera for Horizontal Surfaces.
• Image Sensor: 1099 HD CCD
• Mirror/Normal Image Adjustment.
• TV Lines: 480
• Fixed Angle Mounted
• Horizontal Angle: 170 Degrees
• Vertical Angle: 120 Degrees
• Resolution: 976 x 496
• Minimum Illumination: 0.1 Lux
• TV System: NTSC/PAL
• Video Output: 1.0V p-p 75ohm
• Operating Voltage: 12V DC (Negative Ground)
• Current Consumption: 120mA @ 13.8V
• Waterproof Rating: IP68
• Operating Temperature: -20 Degrees C to +70 Degrees C
• Parking Lines: Yes
• Removable Lines: Yes
• Image Adjustment: Yes (Mirror/Normal)
• Enhanced Performance In Low Light: Yes
• Connects2 part number - CAM-17
• 2 year warranty

Universal reverse camera - Contents

• Camera with 1m cable to mini Male 6 pin connector.
• 1m camera connection cable with mini Female 6 pin connector and RCA Female connector.
• 6m Male to Male RCA extension cable.
• 18mm hole saw.
• Instructions.

Universal reverse camera - Installation

• Read the manual prior to installation. Technical knowledge is necessary for installation. Please ensure you use the correct tools to avoid damage to the vehicle or product.
• 1. Connect the Black wire to a suitable ground and the Red wire to a switched +12V supply.
• 2. If the camera is to be used in the rear of the vehicle, the Red wire should be connected to the reversing light circuit or an interface which provides a reverse signal.
• 3. Select a suitable location for the camera and ensure that the area is free from all cables, fuel & oil. Whenever possible, avoid locations that are subject to road dirt & water spray.
• 4. Aim to mount the camera preferably 45-60cm from the ground and cut a suitable hole using the cutting tool provided.
• 5. Using the supplied video cable, connect the camera to the display screen and ensure that the image is displayed correctly.
• 6. To swap the image from mirror to normal view, cut the small White looped wire which is located on the camera connection cable.
• 7. To remove the parking line feature, cut the small Blue looped wire which is located on the camera connection cable.